Forum Linux.noyau Message d'erreur SCSI sur toutes les consoles

Bonjour à tous,

depuis hier j'ai des messages d'erreur sur un de nos server au boulot, cela concerne le SCSI:

Voilà un extrait du dmesg:

tg3: eth0: Link is up at 100 Mbps, full duplex.
tg3: eth0: Flow control is on for TX and on for RX.
lp0: using parport0 (polling).
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
st: Version 20040102, bufsize 32768, max init. bufs 4, s/g segs 16
Attached scsi tape st0 at scsi0, channel 0, id 3, lun 0
st0: Block limits 1 - 16777215 bytes.
Current sd08:13: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:11: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:13: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
Current sd08:13: sense key Recovered Error
Additional sense indicates Failure prediction threshold exceeded
bash-2.05a#


Le server est composé de deux disques dur SCSI de 73Gb, en RAID1 et d'un système de sauvegarde sur bande HP Ultirum 300Gb, le tout piloté par un contrôleur: Adaptec 29160 Ultra160 SCSI.

Voilà ce que me resort un cat /proc/scsi/scsi:Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: IBM-ESXS Model: MAX3073NC FN Rev: CA06
Type: Direct-Access ANSI SCSI revision: 04
Host: scsi0 Channel: 00 Id: 01 Lun: 00
Vendor: IBM-ESXS Model: MAX3073NC FN Rev: CA06
Type: Direct-Access ANSI SCSI revision: 04
Host: scsi0 Channel: 00 Id: 03 Lun: 00
Vendor: HP Model: Ultrium 1-SCSI Rev: P53D
Type: Sequential-Access ANSI SCSI revision: 03
Host: scsi0 Channel: 00 Id: 08 Lun: 00
Vendor: IBM Model: 02R0980a S320 1 Rev: 1
Type: Processor ANSI SCSI revision: 02


J'ai l'impression que c'est mon HP Ultrium qui commence à lacher, ce que je rouve étrange c'est le "sd08:11" qui correspond à la dernière ligne du cat /proc/scsi/scsi et je ne sais pas ce que c'est. J'ai peur que ce soit un des disques dur.

J'aimerais aussi pouvoir rediriger ces messages dans un fichier de log, actuellement tout les utilisateurs qui ont une session sur ce serveur reçoivent les messages d'erreur.